4. Patches
4.1. Error during the first restart following an update to v2.5.4.0.
In some cases, following the update to v2.5.4.0, a problem may occur during the first restart.
This problem is fixed in v2.5.4.1.
4.2. Blocking of the update in v2.5.4.0.
If the /boot is full, the GCap update might get stuck.
This problem is fixed in v2.5.4.1.
4.3. After the update, error in executing commands with certain hardware versions
Some commands are non-functional for certain hardware versions following an update to 2.5.4.0.
This problem is fixed in v2.5.4.1.
4.4. Sigflow: error when starting the detection engine
On some GCap models, the detection engine does not start if more than two capture interfaces are enabled.
This problem is fixed in v2.5.4.1.
4.5. Sigflow: XDP filters do not apply correctly
In some cases, the XDP filters do not apply correctly.
This problem is fixed in v2.5.4.1.
4.6. Sigflow: receiving specific packets from the Modbus protocol may cause a restart of the engine
When activating the Modbus protocol, receiving a specific packet can cause the engine to restart.
This problem is fixed in v2.5.4.1.
4.7. Netdata: absence of certain metrics
Some metrics are no longer retrieved by Netdata in version 2.5.4.0.
This problem is fixed in v2.5.4.1.